Yep, I’ve been gone for about 1 month. I was working hard on a big post about… something which I’ll write about later. In the meantime, since I do not have running water in the shop I made a little wall-hanging sharpening station. It’s already quite dirty from use, and it works fantastic!
The whole thing is made of white pine 2”x4”, 18mm birch plywood and the following parts:
1/2” female pipe thread to 1/2” barb. Note the shape, the low-profile is very important. Big thanks to my wife for finding this piece! It was a pain in the ass to figure out how to get this put together and locate that specific part until she stepped in.
Submersible fountain pump. Note that the tubing and 1/2” adapter that you purchase must be compatible with the pump you choose. The pump that I purchased is a bit too powerful, but oh well!
Loc-Line Coolant Hose. DO NOT CHEAP OUT AND BUY OFF BRAND. I made this mistake. Loc-line is superior!
How you build the basin and cabinet is up to you. I have it finished in 5 coats of water-based polyurethane, waxed then sealed with 100% silicone sealant. The basin is totally water tight.
How it works is simple. The pump pumps water from a bucket up to some vinyl pipe that’s hidden in a channel behind the cabinet. The basin has vinyl tubing going back to the bucket. The pump is placed on the side of the bucket to minimize sediment pickup, and I will be adding a filter for the drain hose.
I used a footswitch (barely seen in the lower right) to activate the pump, and there’s LED strip lighting (I pulled a piece so you can see it) under the shelf for lighting.
If someone needs the plans, I can put it together in sketchup. I do think that if you’re capable of building it, you should be capable of designing something that works for your situation though!
This post took 45 minutes to research, photograph, write and edit. If you appreciate the information presented then please consider joining patreon or donating!